Group 21 Service procedures - engine
77
6
A = Outer vibration damper (Generating set engines)
Fit the pulley and the outer vibration damper (if any). Use
new O-rings on the bolts. Torque: See ”Workshop manual,
Technical Data”.
7
Install the fan belts.
Sealant, flywheel casing,
replacing
(Flywheel removed)
1
Remove the flywheel casing from the cylinder block.
2
Remove the old sealant from the cylinder block and on the
flywheel casing.
3
Apply an even 2 mm (0.080") thick bead of sealant (part No.
1161277-7) to the block.
4
Fit the flywheel casing to the cylinder block.
Note: The flywheel casing must be refitted within 20 min-
utes of applying the sealant. Torque 140 Nm (103.3 ft-lb).
To Next Page
Loading...
Need help?
General
