49
Delete the announcement
1. Press MENU on the cordless handset in
idle mode to enter the main menu.
2. Press q or p to choose Answering
sys then press SELECT.
3. Press SELECT to select Announcement.
4. Press q or p to choose Reset annc
then press SELECT. The screen
shows Reset to default annc?. Press
SELECT again to confirm. The screen
shows Annc. reset to default before
returning to the previous menu.
- OR -
1. Press MENU on the cordless handset in
idle mode to enter the main menu.
2. Press q or p to choose Answering
sys then press SELECT.
3. Press SELECT to select Announcement.
4. Press q or p to choose Play annc
then press SELECT.
5. While it plays the announcement,
press DELETE. The handset displays
Annc. reset to default.
• After you deleted your own recorded
announcement, the answering system
answers calls with the default announcement.
Voice guide to set Answering
system
This feature is an alternative way for you
to do the basic setup of the answering
system. You can follow the voice guide to
record your own announcement, set the
number of rings, and set the message alert
tone.
1. Press MENU on the cordless handset in
idle mode to enter the main menu.
2. Press q or p to choose Answering sys
and then press SELECT.
3. Press q or p to choose Voice guide
and then press SELECT. You hear a
voice prompt, “This voice guide will
assist you with the basic setup of your
answering system.“
4. Setup your answering system by
inputting designated numbers, as
instructed in the voice guide.
• You can press CANCEL on the cordless
handset to quit the voice guide at any time.
• After a power outage, the system prompts
you to set the date and time, and Smart call
blocker. After these settings are done or
skipped, the system prompts if you want to
set up the answering system via voice guide.
Press SELECT to start the setup.
To Next Page
Loading...
Need help?
General
