50
Set number of rings
You can set the answering system to
answer an incoming call after two, three,
four, five or six rings; or toll saver.
If you choose toll saver, the answering
system answers a call after two rings when
you have new messages, or after four rings
when you have no new messages. This
enables you to check for new messages
and avoid paying unnecessary long
distance charges if you are calling from
outside your local area.
1. Press MENU on the cordless handset in
idle mode to enter the main menu.
2. Press q or p to choose Answering
sys and then press SELECT.
3. Press q or p to choose Ans sys setup
and then press SELECT.
4. Press q or p to choose # of rings and
then press SELECT.
5. Press q or p to choose 6, 5, 4, 3, 2 or
Toll saver and then press SELECT to
save. You hear a confirmation tone.
Set recording time
You can set the recording time for each
incoming message.
1. Press MENU on the cordless handset in
idle mode to enter the main menu.
2. Press q or p to choose Answering
sys and then press SELECT.
3. Press q or p to choose Ans sys setup
and then press SELECT.
4. Press q or p to choose Recording
time and then press SELECT.
5. Press q or p to choose 3 minutes,
2 minutes or 1 minute, and then
press SELECT to save. You hear a
confirmation tone.
Turn the call screening on or off
You can hear incoming messages at the
telephone base while they are being
recorded.
1. Press MENU on the cordless handset in
idle mode to enter the main menu.
2. Press q or p to choose Answering sys
and then press SELECT.
3. Press q or p to choose Ans sys setup
and then press SELECT.
4. Press SELECT to select Call screening.
5. Press q or p to choose On or Off, and
then press SELECT to save. You hear a
confirmation tone.
Turn the message alert tone on or
off
When the message alert tone is set to on,
and there is at least one new message, the
telephone base beeps every 10 seconds.
1. Press MENU on the cordless handset in
idle mode to enter the main menu.
2. Press q or p to choose Answering sys
and then press SELECT.
3. Press q or p to choose Ans sys setup
and then press SELECT.
4. Press q or p to choose Msg alert
tone, and then press SELECT.
5. Press q or p to choose On or Off, and
then press SELECT to save. You hear a
confirmation tone.
• The answering system must be turned on for
the message alert tone to be functional.
• Press any key on the telephone base (except
PAGE) to temporarily silence the message
alert tone.
To Next Page
Loading...
Need help?
General
