59
To register a Wearable home SOS
pendant:
1. When the telephone is not in use,
press and hold PAGE at the telephone
base for about five seconds until the
visual ringer indicator light turns on.
Release PAGE.
2. Press and hold CANCEL on the back
of the SOS pendant until the LED light
on the front flashes, then release the
button. When registration is successful,
the LED light turns off, and then the
base beeps once.
It takes up to 60 seconds to complete
the registration. When the registration is
successful, the red LED lights on the SOS
pendant turns off, and the telephone base
beeps and its visual ringer indicator light
turns off.
If registration fails, start again from Step 1
above.
For detailed installation and operation
instructions, refer to the SOS emergency
call section in this manual, and the user’s
manual of your Wearable home SOS
pendant.
Audio doorbell
(Model SN7021 , purchased
separately)
If you have purchased and registered an
Cordless audio doorbell (SN7021) to the
telephone base, the Doorbell sub-menu
option appears in the Set device menu of
the cordless handset. You can set up your
Cordless audio doorbell, for example, set
the chime volume and tone, and divert
doorbell calls to a preset number. You can
also record doorbell calls.
Set chime volume
1. Press MENU on the cordless handset in
idle mode to enter the main menu.
2. Press q or p to choose Set device
and then press SELECT.
3. Press q or p to choose Doorbell and
then press SELECT.
4. Press SELECT to select Chime.
5. Press SELECT again to select Chime
volume.
6. Press q or p to choose from Volume
1 to Volume 5 and then press SELECT
to save.
Set chime tone
1. Press MENU on the cordless handset in
idle mode to enter the main menu.
2. Press q or p to choose Set device
and then press SELECT.
3. Press q or p to choose Doorbell and
then press SELECT.
4. Press SELECT to select Chime.
5. Press SELECT again to select Chime
tone.
6. Press q or p to choose from Tone 1 to
Tone 5, or Off, and then press SELECT
to save.