58
Add and register a new device
• You need to register your newly purchased
devices to the telephone base before use.
• Make sure the new devices are powered
on with batteries or with AC power before
registering them to the telephone base.
To register an Extension ringer
(SN7014):
1. When the telephone is not in use,
press and hold PAGE at the telephone
base for about five seconds until the
visual ringer indicator light turns on.
Release PAGE.
2. Press and hold the pair button on
the right side of the extension ringer
until the green LED light on the front
flashes, then release the button. When
registration is successful, the green
LED light becomes steady on, and
then the base beeps once.
It takes up to 60 seconds to complete
the registration. When the registration
is successful, the green LED light on the
Extension ringer turns to steady on, and
the telephone base beeps and its visual
ringer indicator light turns off.
If registration fails, start again from Step 1
above.
For detailed installation and operation
instructions, refer to the user’s manual of
your Extension ringer.
To register an Audio doorbell:
1. When the telephone is not in use,
press and hold PAGE at the telephone
base for about five seconds until the
visual ringer indicator light turns on.
Release PAGE.
2. Press and hold the pair button on the
back of the audio doorbell until the
chime button LED light flashes, then
release the button. When registration
is successful, the chime button LED
light becomes steady on, and then the
base beeps once.
It takes up to 60 seconds to complete
the registration. When the registration is
successful, the chime button LED light on
the front of the Audio doorbell turns to
steady on, and the telephone base beeps
and its visual ringer indicator light turns off.
If registration fails, start again from Step 1
above.
For detailed installation and operation
instructions, refer to the Audio doorbell
section in this user’s manual, and the user’s
manual of your Cordless audio doorbell.