Putting into operation
T00962GB 45
The following steps must be carried out: For the correct
adjustment of the idling speed
Start the engine and run it until it is warm (about 3 - 5 minutes).
Carry out carburetor adjustment with the scope of delivery.
Readjusting the idle speed
Proceed as follows if the cutting blade is turning while the engine is
idling: turn the throttle valve‘s stop screws (2) outwards until the cutting
blade stops moving. Turn the screw back in if the engine stops running
while idling.
Stop engine
46
47
To Next Page
Loading...
Need help?
General
