Maintenance
T00963GB 59
8.12 Instructions for periodic maintenance
To ensure long life, prevent damage and ensure the full functioning of
the safety features the following maintenance must be performed
regularly. Warranty claims can be recognized only if this work is
performed regularly and properly. Failure to perform the prescribed
maintenance work can lead to accidents!
Users of the cut-off saw must not perform any maintenance work not
described in this Instruction Manual. All such work must be carried out
by a WACKER service station.
General Entire Power Cut Clean exterior, check for damage. In case of
damage, have repaired by a qualified service
centre immediately
Cutting blade
Clutch
Inspect regularly for damage and wear.
Protection hood Clean, check position
Before
each start
Cutting blade Check for damages and make sure the correct
cutting blade for the planned aplication has
been filted.
V-belt Check V-belt tension.
Combination
switch, Safety
locking button,
Throttle lever
Functional check.
Fuel tank plug Check for tightness.
Every day Prefilter Clean. (Replace after 20 running hours)
Idle speed Check (cutting blade must not turn on idle).
Every
week
Fan housing Clean to ensure proper air cooling.
Starter Check for damage.
V-belt Check V-belt tension, inspect for damage and
wear.
Air filter cartridge Clean. (Replace after 100 running hours)
Spark plug Check and replace if necessary.
Muffler Check tightness of mounting.
Every 3
months
Suction head Replace.
Fuel tank Clean.
Bearing
Clutch drum
Clean and regrease.
To Next Page
Loading...
Need help?
General
