Putting into operation
T00962GB 44
ATTENCION: Do not pull out the starter rope more than approx. 50 cm
(20 feet), and lead it back by hand.
Move the combination switch (42/5) to the position “I“.
Keep pulling the starter rope until the engine starts running.
As soon as the engine is running, press the throttle (42/8) to release
the half-throttle lock (42/6), allowing the engine to idle.
7.8 Warm-starting
As described under „Cold starting“, except without moving the
combination switch (42/5) to the choke position.
7.9 Stopping the engine
Push the combination switch (9) down to position
7.10 Adjusting the carburetor
NOTE: The cut-off saw has been equipped with an
electronic ignition to limit the speed. The carburetor
also has a fixed jet which cannot be adjusted.
At the factory the idling speed has been set to approx.
2.500 1/min, but the running-in process of a new engine may
require slight readjustment of the idling speed.
44
45
Set the idling speed with a screwdriver (width
of blade: 4 mm) (0,16“).
The screwdriver shown has a molded-on lug to
assist in adjustment.
To Next Page
Loading...
Need help?
General
