Maintenance
T00963GB 57
8.11 Repositioning the cutting arm
Loosen nuts (5).
Loosen the tightening screw (3) (counter-clockwise) until the end of the
screw (4) is visible in the gap. Unscrew the nuts (5) and remove the
cover (6).
Lift out stop bolt (7) with universal wrench (8) as shown in drawing until
protective hood (10) can be turned.
NOTE: The turning stop (65/7) is not active when the stop bolt (7) has
been pulled. The protective hood (10) can thus be turned further than
normally allowed by the turning stop (65/7).
Disengage V-belt and then remove cutting arm.
65
66
To Next Page
Loading...
Need help?
General
