FBTS
T00964GB 63
9.2 Safety precautions
9.2.1 The mounting brackets for the cut-off saw must be cleaned before
placing the BTS into the guide cart.
9.2.2 The stop bolt must be correctly engaged to avoid a possible detaching
of the cut-off sawduring applications.
9.2.3 Be careful to verify that both the clamp lever for the cutting depth
setting and the star-shaped knob for the handle height setting are
tightly screwed down during cutting applications.
9.2.4 The guide cart should be cleaned with water after each use to avoid
possible malfunctions.
9.2.5 Park the equipment on an even, horizontal surface during work breaks,
storage or transport. Also make sure that the equipment has been
secured against tipping over or rolling away.
9.2.6 Push the throttle lever to the idle position (forwards) immediately after
ending the cutting process.
To Next Page
Loading...
Need help?
General
