USING INTUOS2
Page 40
Contents
Index
USING THE LENS CURSOR
The Intuos2 Lens Cursor is an input device that allows you to enter precise coordinate position information
into your computer. The Lens Cursor reports the position of the cross-hair to the computer. This makes
the Lens Cursor especially useful for tracing and digitizing drawings into graphics and CAD applications.
By default, the Lens Cursor is set to M
OUSE MODE, which means you can position the screen cursor like
you do with a regular mouse. When using the Lens Cursor to digitize a drawing, the Lens Cursor must be
set to P
EN MODE.
Refer to Customizing the 4D Mouse and Lens Cursor for information on programming the Lens Cursor
buttons.
Click Button
Double-Click Button
Simulates a CTRL+CLICK by default.
Rotate lens for best viewing angle.
Rear Buttons are ignored by default.
Important:
When the Lens Cursor is not
in use, place it on your desk. Leaving an
Intuos2 tool on the tablet may interfere
with screen cursor positioning when
using other pointing devices.
To Next Page
Loading...
Need help?
General
