Safety | 2 | English
Operating instructions CTR Series | 89014478; 2020-06 | 7
2.5 Electrical dangers
Danger
Electric shock from live components
A fatal electric shock can occur when the warewasher and its additional devices are connected to the elec-
trical mains supply.
Ø The warewasher and its additional devices may be connected to the electrical mains supply only by a
specialist company registered within the electrical trade and approved by the energy supplier.
Ø All locally applicable standards and regulations must be observed during the connection to the electrical
mains supply.
Ø When performing installation and maintenance work as well as repairs, unplug the warewasher from the
mains supply. Check that there is no voltage present.
Danger
Electric shock from live components
A fatal electric shock can occur during installation and maintenance work and when carrying out repairs.
Ø Isolate and lockout the mains supply to the warewasher.
Ø Check that there is no voltage present.
2.6 Thermal dangers
Caution
Damage due to hot components
Insufficient distance between electrical cables or dosing tubes and hot components when installing access-
ory devices can lead to damage.
Ø Ensure to lay electrical cables or dosing tubes at a sufficient distance.
2.7 Handling of chemicals
Danger
Risk of chemical burns due to chemicals
Contact between chemicals with the skin or eyes can lead to severe burns or serious eye damage.
Ø In the event of contact with the eyes or skin, rinse thoroughly with tap water. Seek medical attention as
required.
Ø Wear protective clothing, protective gloves and protective goggles.
Ø Observe the danger and safety notes on the container and safety data sheet.
Danger
Risk of poisoning due to chemicals
Contact with the chemicals via the mouth can lead to severe poisoning.
Ø Never drink or transfer chemicals into other containers.
Ø Observe the danger and safety notes on the safety data sheet.
Ø Observe the danger and safety notes on the container and safety data sheet.
2.8 Safety settings
The commercial warewasher has been built in accordance with the applicable legal provisions and is safe to operate.
Danger areas that cannot be excluded by design are fitted with safety devices.
– Door limit switch
– Table limit switch
– Geared motor limit switch overload protection
All safety devices must be present and functional when operating the commercial warewasher.
Safety devices must not be changed or modified.
Carry out a functional check of the safety devices after concluding maintenance and repair work.
2.9 Notes on spare parts
Only original Winterhalter spare parts may be used for maintenance and repairs. Using third-party spare parts voids the
warranty. The information in the spare parts catalogues is decisive in this respect.
Maintenance work and repairs may only be carried out by authorised Winterhalter service technicians. Improper mainten-
ance or repairs may cause significant danger to the user, for which Winterhalter is not liable.
To Next Page
Loading...
Need help?
General
