Xenon 1900 User Manual

3 - 26
To put the scanner in multiple scanner mode, scan the bar code below. Once
you scan this bar code, the scanner is unlinked from the base or Access Point
and must either be placed into the base, or you must scan the Access Point link-
ing bar code in order to relink.
Scanner Name
You may assign a name to each scanner you are using for identification pur-
poses. For example, you may want to have a unique identifier for a scanner that
is receiving imaging commands sent from the base or Access Point.
The default name is in the format “ScannerName_Model_SN_XXXXXXXXXX”
If you have more than one scanner linked to a base, and they all have the same
name, the first scanner linked to the base receives commands. When renaming
a series of scanners with identical names, unlink all except one of the scanners
from the base.
Perform the rename operation using either the bar codes on page 3-27, or by
sending the serial command :
ScannerName :BT_NAM NewName . where
ScannerName is the current name of the scanner, and NewName is the new
name for the scanner. If you wish to change the names of additional scanners,
link them one at a time and repeat the :
ScannerName :BT_NAM NewName .
command for each scanner.
To rename scanners with sequential, numeric names, scan the bar codes
below.
Scan the Reset code after each name change and wait for the scanner
to relink to the base or Access Point before scanning a bar code to rename the
next scanner.
Multiple Scanner Operation
0001
0002
0003

Xenon 1900 Specifications

General

Brand	Xenon
Model	1900
Category	Barcode Reader
Language	English