4 - 4
Vibrate – Good Read
Note: Vibration settings apply only to Granit Devices.
The scanner vibrates once when a bar code is successfully read, and twice
when a programming bar code is successfully read. When a programming
bar code is unsuccessful, the scanner emits one long vibration (2 times the
Vibrate Duration length). Scan Vibrate - Good Read Off to keep the scan-
ner from vibrating.
Default = Vibrate - Good Read On.
Vibrate Duration
If you want to set the length for the good read vibration, scan the bar
code below, then set the duration (from 100 - 2,000 milliseconds) by
scanning digits from the inside back cover, then scanning Save.
Default = 300 ms.
* Medium - Granit
(3200 Hz)
* Vibrate- Good Read On
Vibrate- Good Read Off
To Next Page
Loading...
Need help?
General