Xerox AltaLink B8145 Series User Manual

SSYYMMPPTTOOMM SSOOLLUUTTIIOONNSS
• Change the Paper Type settings in the print driver.
In the print driver, on the Printing Options tab,
select PPaappeerr, then change the Other Type setting.
• Check the percentage of remaining life for the
transfer belt. For details, refer to Supply Status.
When the percentage of remaining life is less than
20 percent, replace the transfer belt cleaner. For
details, refer to Replacing the Transfer Belt Cleaner
• Replace the toner cartridge.
• If the error persists, contact your Xerox
representative.
Auger marks appear on the printed output.
• To check the toner level, check the control panel, or
use the print driver or the Embedded Web Server.
For details, refer to Supply Status. If the toner
cartridge is near empty, replace it.
• Verify that the toner cartridge is approved for use in
this printer, and replace the toner cartridge, as
needed. For best results, use a Genuine Xerox toner
cartridge.
• Replace the toner cartridge.
• If the error persists, contact your Xerox
representative.
The output print is wrinkled or stained.
• Verify that the paper is the correct size, type, and
weight for the printer and that the paper is loaded
properly. If not, change the paper.
• Try a new ream of paper.
• Change the Paper Type settings in the print driver.
In the print driver, on the Printing Options tab,
select PPaappeerr then change the Other Type setting.
Envelopes are wrinkled or creased when printed. Verify that the crease is within 30mm (1.2 in.) of the
four edges of the envelope.
• If yes, the printer is printing as expected. Your
printer is not faulty.
• If not, take the following actions:
– Ensure that only C5 envelopes are loaded in
Bypass Tray
– Ensure that envelopes are loaded properly in
Xerox
®
AltaLink
®
B8145/B8155/B8170 Series Multifunction Printer User Guide 341
Troubleshooting

Xerox AltaLink B8145 Series Specifications

General

Brand	Xerox
Model	AltaLink B8145 Series
Category	All in One Printer
Language	English