Xerox Phaser 3330 System Administrator Guide

Network Connectivity
22 Xerox
®
Phaser
®
3330 Printer
System Administrator Guide
9. For Zero-Configuration Networking, perform the following steps.
− To configure the printer to assign itself an address if a DHCP server does not provide one, for
Self-Assigned Address, select Enabled.
− To allow users to see and connect to the printer using Bonjour, for Multicast DNS, select
Enabled.
10. Click Apply.
Configuring IPv6
IPv6 hosts can automatically configure themselves when connected to a routed IPv6 network using the
Internet Control Message Protocol Version 6 (ICMPv6). ICMPv6 performs error reporting for IP along
with other diagnostic functions. When first connected to a network, a host sends a link-local multicast
router solicitation request for configuration parameters. If suitably configured, routers respond to this
request with a router advertisement packet containing network-layer configuration parameters.
1. In Xerox
®
CentreWare
®
Internet Services, click Properties > Connectivity > Protocols.
2. Click TCP/IP.
3. To enable TCP/IPv6, for Protocol, select Enabled.
4. Under Default Dynamic Host Configuration Protocol (DHCP) Settings, select how DHCP operates
for IPv6.
5. To specify an address manually, perform the following steps.
− For Manual Address, select Enabled.
− Select a Router Prefix from the menu, or to populate the prefix for manual entry address,
click Add.
6. To configure DNSv6, perform the following steps.
− Enter a valid IPv6 Domain Name.
− For Primary DNSv6 Server Address, enter an IP address.
− For Secondary DNSv6 Server Address, enter an IP address.
− To enable Dynamic DNSv6 Registration, select Enable.
7. Click Apply.

Xerox Phaser 3330 Specifications

General

Brand	Xerox
Model	Phaser 3330
Category	Printer
Language	English