Installation and Setup
Xerox
®
WorkCentre
®
6025 Multifunction Printer 49
User Guide
Configuring System Settings
This section includes:
• Accessing the System Settings Menu .......................................................................................................................... 49
• Setting the Power Saver Mode Timers ........................................................................................................................ 49
• Setting the Auto Reset Timer .......................................................................................................................................... 49
• Setting the Fault Time-Out Timer ................................................................................................................................. 50
• Setting the Job Time-Out Timer .................................................................................................................................... 50
• Setting the Clock .................................................................................................................................................................. 50
• Setting Alerts ......................................................................................................................................................................... 50
• Setting the Units for Custom Paper Sizes .................................................................................................................. 50
• Setting the Low Toner Alert ............................................................................................................................................. 51
•
Setting the Show Paper Size/Type Error ..................................................................................................................... 51
You can use this menu to configure general settings of the printer, such as Power Saver timers, clock
settings, and alert settings.
Accessing the System Settings Menu
1. On the printer control panel, press the System button.
2. Use the Up and Down arrows to navigate to Admin Menu, then press OK.
3. Navigate to System Settings, then press OK.
Setting the Power Saver Mode Timers
1. In the System Settings menu, navigate to Power Saver Timer, then press OK.
2. Select the Power Saver Mode you want to change, then press OK.
3. To select the desired time, press the arrow buttons, or enter a value using the numeric keypad.
− Power Saver Mode 1 (Low Power): Set the timer from 1–60 minutes.
− Power Saver Mode 2 (Sleep): Set the timer from 1–60 minutes.
4. Press OK.
Setting the Auto Reset Timer
You can specify the time the printer waits for further input before it returns to standby mode.
To set the Auto Reset timer:
1. In the System Settings menu, navigate to Auto Reset, then press OK.
2. To select a setting, press the arrow buttons, select it, then press OK.
To Next Page
Loading...
Need help?
General
