Yaesu FT3DR User Manual

25
Changing the Frequency Step
The DIAL knob rotation frequency step may be changed. Normally, the factory default
setting will provide a good frequency step.
1. Press and hold the [DISP] key, then touch [CONFIG].
2. Touch [18 STEP] then rotate the DIAL knob to change the frequency step.
3. Press the PTT switch to save the setting and return to normal operation.
In the default setting, of the frequency step is set to “AUTO”, which automatically provides
a suitable frequency step according to the frequency band.
Selecting the Communication Mode
z
Using AMS
The FT3DR/DE transceiver is equipped with the AMS
(Automatic Mode Select) function which automatically
selects the communication mode corresponding to the
received signal.
To utilize the AMS function, touch [MODE] repeatedly
to display “
*”, “ *” or “ *” on the display. After
receiving the signal, “FM” of “
” will change to indicate
the mode of the received signal.
*The display differs depending on the received signal.
z
Setting the transmit mode when using the AMS
function
The AMS function will automatically set the receiver to
the mode of the received signal, but the transmit mode
may be fixed regardless of the received mode.
1. Touch [AUTO]* to tune to the desired transmit mode
as follows.
*The display differs depending on the transmit mode.
Transmit Mode
Receive and Transmit
AUTO
(default)
Receive׃ Automatically selects the receive mode corresponding to the received sig-
nal.
Transmit:
Automatically transmits in the communication mode selected by the AMS
function.
TX FM
Receive׃ Automatically selects the receive mode corresponding to the received sig-
nal.
Transmit:
Always transmits in the analog FM mode.
TX DN
(TX DIGITAL)
Receive׃ Automatically selects the receive mode corresponding to the received sig-
nal.
Transmit׃ Always transmits in the DN mode.

Yaesu FT3DR Specifications

General

Brand	Yaesu
Model	FT3DR
Category	Transceiver
Language	English