FTA-750/FTA-550 OperATing MAnuAl
65
Recording the Position Information
The
FTA-750
includes a logger for position information
that allows you to record your location at a regular
interval.
1.
Press the
[
MENU
]
key to display the
MENU
screen
.
2. Select
“
FUNC
” on the screen by pressing the
[
◄
]
or
[
►
]
key, and then press the
[
ENT
]
key.
3. Select
“
LOGGER
” on
the screen by pressing
the
[
◄
]
or
[
►
]
key, and
then press the
[
ENT
]
key.
SCAN MEM
DUAL WATCH
SCAN
SPLIT
LOGGER
OFF
OFF
OFF
OFF
OFF
FUNCTION
The recording starts and the display returns to the
previous screen with the “ ” icon on the top of
the display.
You may change the interval time of recording via
the SETUP mode.
Notes:
The power save operation of the GPS unit is dis-
abled while the logger is activated.
To utilize the records, connect the
FTA-750
to a PC
and take the log data from the radio by using the PC
Programming Software
YCE01
(the
YCE01
may
be downloaded through the YAESU website).
Logger operation alert
When the memory for log data becomes full, three
beeps will sound and a warning message will be
displayed.
Afterwards the logger does not operate until the log
data in the memory are erased.
When the logger cannot record for some reasons,
three beeps will sound and a warning message will
be displayed.
Afterwards the logger does not operate anymore.
An error message will be displayed when the radio
cannot erase the log data in the memory during the
operation following the alert of memory full (see
above) or in the SETUP mode (see Page 79).
gps FunctIon (Fta-750 only)
To Next Page
Loading...
Need help?
General
