58
The navigation function of the FTA- 850L is displayed
on the compass screen, which allows checking the
destination direction and direction of travel at a glance.
The destination or route can be selected from pre-saved
memory or previously used history, or you can enter a
new latitude and longitude to set it as the destination.
During route navigation, you can check the section
currently in ight, the next waypoint, and the entire
route on the easy-to-understand route display screen.
Notes:
Be sure that the internal GPS unit has been acti-
vated before using the navigation.
The navigation does not work when insucient
number of GPS satellites are captured to obtain
your position.
Starting Navigation
1. Press the
[
MENU
]
key to display the MENU screen.
2. Select “NAVI” on the screen
by pressing the [▲] or [▼]
key, and then press the
[ENT] key.
The screen for selecting the
destination is displayed.
Select the destination or the route
There are three ways to select a destination or route:
Select a destination or route from memory
Select the stored memory (including latitude and
longitude information) or route to start navigation.
Select a destination or route from the history
Start navigation by selecting from the memory or
route history previously used for navigation.
Enter latitude and longitude directly to set the
destination
Enter a new latitude and longitude to start
navigating to that point.
z
Select a destination or route from memory
1. Press the [▲] / [▼] keys to
select “Memory” and press
the [ENT] key.
NAVIGATION
To Next Page
Need help?
General
