49
Setting Modes
FT-891 Operating Manual
FM SETTING
This setting mode is used for the FM mode functions.
(
This screen may be enabled/disabled via Menu Mode “05-10
[
FM SETTING
]
”. Default: Disable
)
MULTI
Knob
Function
T/DCS
Press
• Activate the CTCSS or DCS operation on FM mode, the CTCSS/DCS
function selection pop-up screen will appear. Rotate the MULTI function
knob to select the desired CTCSS/DCS function, then press the MULTI
function knob to close the pop-up screen.
• Press the MULTI function knob to turn the CTCSS or DCS operation OFF.
TONE
Press
Rotate the MULTI function knob to select the CTCSS tone frequency
(
see
table below
)
, then press the MULTI function knob to close the pop-up screen.
DCS
Press
Rotate the MULTI function knob to select the DCS code
(
see table below
)
,
then press the MULTI function knob to close the pop-up screen.
RPT
Press
Rotate the MULTI function knob to select the offset direction of the uplink
frequency shift
(
+, – or simplex
)
during FM repeater operation, then press the
MULTI function knob to close the pop-up screen.
REV
Press
Reverse the transmit and receive frequencies while working through a re-
peater.
NOTE: For details, refer to the Advanced Manual
(
download from the Yaesu website
)
.
CTCSS TONE FREQUENCY
(
Hz
)
67.0 69.3 71.9 74.4 7 7. 0 79.7 82.5 85.4 88.5
91.5 94.8 97.4 100.0 103.5 107. 2 110.9 114.8 118 .8
123.0 127. 3 131.8 136.5 141.3 146.2 151.4 156.7 159.8
162.2 165.5 167.9 171.3 173.8 177.3 179.9 183.5 186.2
189.9 192.8 196.6 199.5 203.5 206.5 210.7 218.1 225.7
229.1 233.6 241.8 250.3 254.1 - - - -
DCS CODE
023 025 026 031 032 036 043 047 051 053
054 065 071 072 073 074 114 115 116 122
125 131 132 134 143 145 152 155 156 162
165 172 174 205 212 223 225 226 243 244
245 246 251 252 255 261 263 265 266 271
274 306 311 315 325 331 332 343 346 351
356 364 365 371 411 412 413 423 431 432
445 446 452 454 455 462 464 465 466 503
506 516 523 526 532 546 565 606 612 624
627 631 632 654 662 664 703 712 723 731
732 734 743 754 - - - - - -