Yamaha PSR-A3000 User Manual

PSR-A3000 Owner’s Manual 159
Songs
3
6 Press the [I] (SAVE) button to carry out the Save operation.
For details, refer to page 28.
NOTICE
The edited Song data will be lost if you select another Song or turn off the power to the instrument without carrying out the Save operation.
Re-recording a Specific Section—Punch In/Out
When re-recording a specific section of an already-recorded Song, use the Punch IN/OUT function. In this method,
only the data between the Punch In point and the Punch Out point is overwritten with the newly recorded data. Keep
in mind that the notes before and after the Punch In/Out points are not recorded over, although you will hear them
play back normally to guide you in the Punch In/Out timing.
NOTE The Style Retrigger function (page 112) cannot be used when recording over existing data (overdubbing).
1 Select the desired Song for re-recording.
2 Call up the operation display.
[FUNCTION]  TAB [F] MENU 2  [B] SONG CREATOR  TAB [E] REC MODE
3 Determine the settings for recording.
[1 ]–
[3 ]
REC START
(Punch In)
Determines the Punch In timing.
NORMAL: Overwrite recording starts when the Song playback is started
via the SONG [
F/ K] (PLAY/PAUSE) button or when you play the key-
board in the Synchro Standby mode.
FIRST KEY ON: The Song plays back normally, then starts overwrite
recording as soon as you play the keyboard.
PUNCH IN AT: The Song plays back normally up to the beginning of the
indicated Punch In measure, then starts overwrite recording at that
point. You can set the Punch In measure by pressing the [3 ] but-
ton.
[4 ]–
[6 ]
REC END
(Punch Out)
Determines the Punch Out timing.
REPLACE ALL: This deletes all data after the point at which recording is
stopped.
PUNCH OUT: The Song position at which recording is stopped is regarded
as the Punch Out point. This setting maintains all data after the point at
which recording is stopped.
PUNCH OUT AT: Actual overwrite recording continues until the begin-
ning of the specified Punch Out measure (set with the corresponding
display button), at which point recording stops and normal playback
continues. This setting maintains all data after the point at which
recording is stopped. You can set the Punch Out measure by pressing
the [6 ] buttons.

Yamaha PSR-A3000 Specifications

General

Pitch wheel	Yes
Product type	Digital synthesizer
Product color	Black, Grey
Sound effects	Flanger/Digital Signal Processing (DSP), Reverberation
RMS rated power	30 W
Number of speakers	2
Chorus effects quantity	106
Keyboard number of keys	61
Preset programs quantity	4
Maximum polyphony (notes)	128
Display type	LCD
Display diagonal	7 \
Power source type	DC

Weight and Dimensions

Depth	437 mm
Width	1002 mm
Height	148 mm
Weight	11200 g