CONFIGURATIONS ➤ Configuring various functions (Setup menu) En 88
❑ ARC
Enables/disables ARC (p.21) when “HDMI Control” is set to “On”.
Settings
• You do not need to change this setting normally. In case noises are produced from the speakers connected
to the unit because TV audio signals input to the unit via ARC are not supported by the unit, set “ARC” to
“Off” and use the TV’s speakers.
❑ Standby Sync
Select whether to use HDMI control to link the standby behavior of the TV and the unit
when “HDMI Control” is set to “On”.
Settings
■ Audio Output
Selects a device to output audio.
• This setting is available only when “HDMI Control” is set to “Off”.
❑ Amp
Enables/disables the audio output from the speakers connected to the unit.
Settings
❑ HDMI OUT
Enables/disables the audio output from a TV connected to the HDMI OUT jack.
Settings
■ Standby Through
Select whether to output videos/audio (input through HDMI jacks) to the TV when the
unit is in standby mode. If this function is set to “On”, you can use the input selection
keys (HDMI 1–5) to select an HDMI input even when the unit is in standby mode (the
standby indicator on the unit blinks).
Settings
• This setting is available only when “HDMI Control” is set to “Off”.
Off Disables ARC.
On (default) Enables ARC.
Off Does not set the unit to standby mode when the TV is turned off.
On Sets the unit to standby mode when the TV is turned off.
Auto (default)
Sets the unit to standby mode when the TV is turned off only when the
unit is receiving TV audio or HDMI signals.
Off Disables the audio output from the speakers.
On (default) Enables the audio output from the speakers.
Off (default) Disables the audio output from the TV.
On Enables the audio output from the TV.
Off (default) Does not output videos/audio to the TV.
On
Outputs videos/audio to the TV.
(The unit consumes approximately 3 W of power.)
To Next Page
Loading...
Need help?
General