Trouble Recovery
97
● Do not touch the ignition coil, spark plug
wire, spark plug cap, or other electrical
components when starting or operating
the motor. You could get an electrical
shock.
EMU29562
Emergency starting engine
1. Remove the top cowling.
2. Remove the start-in-gear protection ca-
ble from the starter, if equipped.
3. Remove the starter/flywheel cover after
removing the bolt(s).
4. Prepare the engine for starting. For fur-
ther information, see page 50. Be sure
the engine is in neutral and that the clip is
attached to the engine shut-off switch.
The main switch must be “ ” (on), if
equipped.
5. If equipped the choke knob, pull out it
when the engine is cold. After the engine
starts, gradually return the choke knob to
its home position as the engine warms
up.
6. Insert the knotted end of the emergency
starter rope into the notch in the flywheel
rotor and wind the rope several turns
around the flywheel clockwise.
7. Give a strong pull straight out to crank
and start the engine. Repeat if neces-
sary.
1. Start-in-gear protection cable
ZMU07894
U6DR30E0.book Page 97 Friday, November 30, 2012 4:27 PM
To Next Page
Loading...
Need help?
General
