EasyManuals Logo

Yamaha T9.9 User Manual

Yamaha T9.9
110 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #64 background imageLoading...
Page #64 background image
Operation
58
ing, return the main switch to
(on), wait 10 seconds, then crank the
engine again.
[ECM00192]
8. Return the neutral throttle lever to the
original position.
TIP:
When the engine is cold, for example, when
the ambient temperature is low in winter, it
needs to be warmed up. For further informa-
tion, see page 58.
EMU36510
Checks after starting engine
EMU36523
Cooling water
Check for a steady flow of water from the cool-
ing water pilot hole. A continuous flow of water
from the pilot hole indicates that the water
pump is pumping water through the cooling
water passages. If the cooling water passag-
es are frozen, it may take a while for water to
start flowing out of the pilot hole.
NOTICE
ECM01810
If water is not flowing out of the pilot hole
at all times while the engine is running,
overheating and serious damage could
occur. Stop the engine and check whether
the cooling water inlet on the lower case or
the cooling water pilot hole is blocked.
Consult your Yamaha dealer if the prob-
lem cannot be located and corrected.
EMU27670
Warming up engine
EMU27716
Manual start and electric start models
1. After starting the engine, allow it to idle for
3 minutes to warm up. Failure to do so will
shorten engine life.
2. Be sure the low oil pressure-alert indica-
tor goes off after starting the engine.
NOTICE: If the low oil pressure-alert
indicator blinks after the engine starts,
stop the engine. Otherwise, serious
engine damage could occur. Check
the oil level and add engine oil if nec-
essary. Consult your Yamaha dealer if
the cause for the low oil pressure alert
cannot be found.
[ECM01831]
EMU36531
Checks after engine warm up
EMU36541
Shifting
While the boat is tightly moored, and without
applying throttle, confirm that the engine shifts
smoothly into forward and reverse, and back
to neutral.
EMU36980
Stop switches
Turn the main switch to “ ”, or press the
engine stop button and make sure the en-
gine stops.
Confirm that removing the clip from the en-
gine shut-off switch stops the engine.
1. Cooling water pilot hole
1
ZMU07830
U6DR30E0.book Page 58 Friday, November 30, 2012 4:27 PM

Table of Contents

Other manuals for Yamaha T9.9

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yamaha T9.9 and is the answer not in the manual?

Yamaha T9.9 Specifications

General IconGeneral
BrandYamaha
ModelT9.9
CategoryOutboard Motor
LanguageEnglish

Related product manuals