Operation
50
8. Wipe up any spilled gasoline immediately
with dry rags.
Dispose of rags properly according to local
laws or regulations.
9. When using the fuel tank on the boat, a
fuel valve may also be equipped on the
boat. Open the fuel valve.
Check the boat’s manual for the position of
the fuel valve.
10. Squeeze the primer pump, with the arrow
pointing up, until you feel it become firm.
During engine operation, place the tank
horizontally, otherwise fuel cannot be
drawn from the fuel tank.
EMU27494
Starting engine
EWM01600
Before starting the engine, make sure that
the boat is tightly moored and that you can
steer clear of any obstructions. Be sure
there are no swimmers in the water near
you.
EMU34813
Manual start models (tiller control)
EWM01840
● Failure to attached engine shut-off cord
could result in a runaway boat if opera-
tor is ejected. Attach the engine shut-off
cord to a secure place on your clothing,
or your arm or leg while operating. Do
not attach the cord to clothing that could
tear loose. Do not route the cord where
it could become entangled, preventing it
from functioning.
● Avoid accidentally pulling the cord dur-
ing normal operation. Loss of engine
power means the loss of most steering
control. Also, without engine power, the
boat could slow rapidly. This could
cause people and objects in the boat to
be thrown forward.
Starting procedure (cold engine)
1. Place the gear shift lever in neutral.
1. Fuel hose
1. Arrow
2. Primer pump
U6DR30E0.book Page 50 Friday, November 30, 2012 4:27 PM
To Next Page
Loading...
Need help?
General
