Operation
61
2. After stopping the engine, disconnect the
fuel hose from the fuel joint on the out-
board motor by turning it counterclock-
wise.
3. Install the fuel joint cap on the outboard
motor.
4. Disconnect the fuel hose from the fuel
joint on the fuel tank by turning it counter-
clockwise.
5. Tighten the air vent screw by turning it
clockwise.
If the outboard motor is equipped with an en-
gine shut-off cord, the engine can also be
stopped by pulling the cord and removing the
clip from the engine shut-off switch.
EMU43440
Procedure
1. Turn the main switch to ā ā (off).
1. Fuel joint
2. Fuel hose
1. Fuel joint cap
1. Fuel joint
2. Fuel hose
1. Air vent screw
U6DR30E0.book Page 61 Friday, November 30, 2012 4:27 PM