Operation
66
2. Disconnect the fuel hose from the fuel
joint on the outboard motor by turning it
counterclockwise.
3. Install the fuel joint cap on the outboard
motor.
4. Place the tilt lock lever (if equipped) in the
release/up position.
5. Pull up the shallow water lever (if
equipped).
6. Hold the rear of the top cowling with one
hand and tilt the engine up fully.
7. Push the tilt support knob into the clamp
bracket. Or the tilt support bar will turn to
the lock position automatically. NOTICE:
Do not use the tilt support lever or
knob when trailering the boat. The out-
board motor could shake loose from
the tilt support and fall. If the motor
cannot be trailered in the normal run-
ning position, use an additional sup-
port device to secure it in the tilt
position. For more detailed informa-
tion, see page 72.
[ECM01641]
EMU32724
Procedure for tilting up (power tilt
models)
1. Place the remote control lever / gear shift
lever in neutral.
1. Fuel joint
2. Fuel hose
1. Fuel joint cap
U6DR30E0.book Page 66 Friday, November 30, 2012 4:27 PM
To Next Page
Loading...
Need help?
General
