Yealink VS800 User Manual

| Configuring Basic Settings | 116
Parameter Description Configuration Method
USB Enable
Enable or disable the USB
feature.
Note: the default value is On.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Configuring Local Storage
VC200/VP59 allows you to storage the images and recorded videos to local storage except for USB storage.
About this task
Note: The priority of local storage is lower than USB storage. When users disable USB storage, the captured
screenshot and recorded files are saved on local storage automatically.
Procedure
1.
On your web user interface, go to Setting > Video & Audio > USB Config > Local Storage Enable.
2.
Configure and save the following settings:
Parameter Description Configuration Method
Local Storage Enable
Enable or disable the local
storage feature.
Note: the default value is On.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Taking Screenshots by Remote Control
You can capture screenshot. This feature is not applicable to VP59.
Before you begin
If you want to save the screenshot to USB flash driver, make sure a USB flash drive is connected, and the USB
feature is enabled.
If you want to save the screenshot to local storage (only applicable to VC200), make sure the local storage is enabled.
Procedure
1.
On your web user interface, go to Setting > Video & Audio > USB Config.
2.
Configure and save the following settings:

Yealink VS800 Specifications

General

Brand	Yealink
Model	VS800
Category	Conference System
Language	English