| Configuring Network Settings | 58
Parameter Description Configuration Method
Host Name
Configure the host name of the system.
Note: When the system broadcasts
DHCP DISCOVER messages, it will
report the configured host name to the
DHCP server via DHCP option 12. For
more information, contact the network
administrator.
If you change this parameter, the
system will reboot to make the change
take effect.
Web user interface
VLAN
The purpose of VLAN configurations on the system is to insert tag with VLAN information to the packets generated
by the system. When VLAN is properly configured for the Internet port on the system, the system will tag all packets
from the Internet port with the VLAN ID. The switch receives and forwards the tagged packets to the corresponding
VLAN according to the VLAN ID in the tag as described in IEEE Std 802.3.
In addition to manual configuration, the system also supports automatic discovery of VLAN via LLDP or DHCP. The
assignment takes effect in this order: assignment via LLDP, manual configuration, then assignment via DHCP.
For more information on VLAN, refer to VLAN Feature on Yealink IP Phones.
•
Configuring LLDP
•
Configuring VLAN Manually
•
Configuring DHCP VLAN
Configuring LLDP
LLDP (Linker Layer Discovery Protocol) is a vendor-neutral Link Layer protocol, which allows the systems to
receive (transmit) the device-related information from (to) the directly connected devices that also uses the protocol
on the network, and to store the information about other devices.
When LLDP feature is enabled on the systems, the systems periodically send their own information to the directly
connected switch (LLDP-enabled). The systems can also receive LLDP packets from the connected switch and obtain
their VLAN IDs, and then communicates with the call control.
•
Configuring LLDP
Configuring LLDP
Procedure
1.
Do one of the following:
• On your web user interface, go to Network > Advanced > LLDP.
• On your VCS:
For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Advanced Network >
LLDP.
On your VC200, go to More > Network > Wired Network > Advanced Network > LLDP.
On your VP59, tap Setting > Advanced > Advanced Network > LLDP.
• On your CTP20, tap Setting > Advanced > Advanced Network > LLDP.
To Next Page
Need help?
General
