Yealink VS800 User Manual

| Configuring Camera Settings | 147
Parameter Description Configuration Method
Select a camera
Select the camera you want to
highlight.
Note:
The first connected camera.
This configuration appears
only if Multi-camera Default
Layout is set to 1+N or Selected
Speaker.
It is not applicable to VC200/
VC500/PVT950.
Web user interface
Viewing Camera Status
This feature is not applicable to VP59.
Procedure
1.
Do one of the following:
• On your web user interface, go to Setting > Camera > Camera Info.
• On your VCS, go to More > Status > Camera.
• On your CTP20, tap Setting > Camera > Camera details.
2.
Configure and save the following settings:
Parameter Description Configuration Method
Camera Name
Customize a name for the
camera.
Web user interface
Model The VCS codec model.
Endpoint
CTP20
IP address The IP address of the selected
camera.
Web user interface
Firmware version The firmware version of the
selected camera.
Web user interface
Hardware version The hardware version of the
selected camera.
Web user interface
SPEC The specification of the selected
camera.
Web user interface
Endpoint
CTP20
MAC address The MAC address of the
selected camera.
Web user interface

Yealink VS800 Specifications

General

Brand	Yealink
Model	VS800
Category	Conference System
Language	English