Yealink VS800 User Manual

| Getting Started | 36
LED Status Description
Wi-Fi profile update fails.
Powering on and off
•
Powering on VC880/VC800/VC500/VC200/PVT980/PVT950
•
Powering off VC880/VC800/VC500/VC200/PVT980/PVT950
•
Powering on or Powering off VP59
•
Initialization Process Overview
Powering on VC880/VC800/VC500/VC200/PVT980/PVT950
Your system starts up automatically after you connect an electrical supply. If you power off the system using the
remote control, do the following to power it on.
Procedure
On your remote control, press .
Your system is powered on successfully, and the LED indicator illuminates solid green.
Powering off VC880/VC800/VC500/VC200/PVT980/PVT950
Procedure
1.
On your remote control, press .
2.
Select Shut down and then press OK key.
The system powers off immediately, and the LED indicator goes out.
Powering on or Powering off VP59
VP59 powers on automatically after you connect an electrical supply, and it powers off when you disconnect an
electrical supply.
Initialization Process Overview
Once connected to the network and an electrical supply, the system begins initializing.
•
Loading the ROM File
•
Configuring the VLAN
•
Querying the DHCP Server
Loading the ROM File
The ROM file, came with the system, is stored in the system flash memory. During initialization, the system runs a
bootstrap loader that loads and executes the ROM file.
Configuring the VLAN
If you connect the system to a switch, the switch notifies the system of the VLAN information defined on the switch.
The system can then proceed with the DHCP request for its network settings (if using DHCP).

Yealink VS800 Specifications

General

Brand	Yealink
Model	VS800
Category	Conference System
Language	English