AF6ZP0CA – COMBIAC0 & ACE0 2uC – User Manual Page – 151/155
When ESC is pressed, console will ask if programmed values must be saved or
discarded.
13.2.7 Lift and Lower commands acquiring
From MAIN MENU enter the Adjustment menu.
With UP and DOWN keys you can scroll the whole list: once you have highlighted
a value that you want acquire press OK.
When OK is pressed the procedure will start:
Select the Enable switch, if any;
Select the control switch if any (either lift or lower);
Move the control sensor (lift/lower potentiometer) to the correct position
according to what you are acquiring.
Displayed values will vary accordingly to operator inputs.
4 Sequence above can slightly vary depending on controller firmware. Anyway the
logic will remain the same: before programming the min/max values, execute any
starting sequence which is necessary, then press the pedal/push the joystick.
It is possible step by step acquire all the values in only one session.
At the end you can press ESC and the console will prompt a request to
confirm/discard changes.
To Next Page
Loading...
Need help?
General
