To Next Page

To Previous Page

Symbologies

176

Code 39

Enable/Disable Code 39

Parameter # 0 (SSI # 00h)

To enable or disable Code 39, scan the appropriate bar code below.

Enable/Disable Trioptic Code 39

Parameter # 13 (SSI # 0Dh)

Trioptic Code 39 is a variant of Code 39 used in the marking of computer tape cartridges. Trioptic Code 39 symbols

always contain six characters. To enable or disable Trioptic Code 39, scan the appropriate bar code below.

*Enable Code 39

(1)

Disable Code 39

(0)

Enable Trioptic Code 39

(1)

*Disable Trioptic Code 39

(0)

NOTE: You cannot enable Trioptic Code 39 and Code 39 Full ASCII simultaneously.

Copyright2
Terms of Use2
Revision History2
About This Guide13
- Introduction13
- Documentation Set13
- Model Configurations14
- Chapter Descriptions14
- Notational Conventions15
- Related Documents15
- Service Information15
- Provide Documentation Feedback16
Getting Started17
- Introduction17
- Unpacking17
- Configuration Features18
- Status Indications19
- RS6000 Activity Modes20
- Configuration21
- Bluetooth Connection23
- Scanning23
  - Scan Triggering Modes23
    - Manual Triggering (Triggered models only)23
    - Auto-triggering (Triggerless models only)23
  - Aiming the RS600024
- Resetting the RS600025
Bluetooth Communications27
- Introduction27
  - Scanning Sequence Examples27
  - Errors While Scanning27
- Bluetooth Communications Parameter Defaults28
- Bluetooth Status Indications29
- Bluetooth Connection Modes29
- Keyboard Emulation29
- HID Options34
- Simple Serial Interface41
  - SSI Setup41
- Serial Port Profile44
  - SPP Setup44
- General Bluetooth Options57
Accessories81
- Accessories81
- 1-Slot RS6000 USB Charging Cradle83
- 2-Slot WT6000/RS6000 USB Charging Cradle86
- 5-Slot RS6000 Charge Only Cradle89
- 10-Slot WT6000/RS6000 Charge Only Cradle92
- 10-Slot RS6000 Charge Only Cradle95
  - Charging the RS600096
  - Battery Charging96
- 4-Slot Battery Charger97
- 20-Slot Battery Charger99
RS6000 Configuration and Update101
- Introduction101
- Configuring the RS6000101
- Real Time Logger102
  - Retrieving the RS6000 Log File102
- RS6000 Firmware Update103
  - Direct USB using 123Scan2104
  - Bluetooth connected WT6000104
Configuring Motion and Proximity105
- Introduction105
- Operation Modes105
- Configuring Motion and Proximity107
- Proximity Distance109
- Good Scan Indication Delay Control110
Miscellaneous Imager Options112
- Introduction112
- Scanning Sequence Examples113
- Errors While Scanning113
- User Preferences/Miscellaneous Options Parameter Defaults113
- User Preferences115
  - Default Parameters115
- Parameter Bar Code Scanning116
- Beep After Good Decode117
  - Beep on Insertion117
- Beeper Volume118
- Beeper Tone119
- Beeper Duration120
  - Suppress Power Up Beeps120
- Low Battery Indication121
- Hand-Held Trigger Mode122
- Hand-Held Decode Aiming Pattern123
- Picklist Mode124
- FIPS Mode125
- Continuous Bar Code Read126
  - Unique Bar Code Reporting126
- Decode Session Timeout127
- Timeout Between Decodes, Same Symbol128
- Timeout Between Decodes, Different Symbol129
  - Fuzzy 1D Processing129
- Decode Mirror Images (Data Matrix Only)130
- Mobile Phone/Display Mode131
- PDF Prioritization132
- PDF Prioritization Timeout133
  - Decoding Illumination133
- Motion Tolerance134
- Miscellaneous Scanner Parameters134
  - Add an Enter Key134
  - Transmit Code ID Character134
  - Prefix/Suffix Values135
  - Scan Data Transmission Format136
  - FN1 Substitution Values138
  - Transmit “No Read” Message139
Symbologies140
- Introduction140
- Scanning Sequence Examples140
- Errors While Scanning140
- Symbology Parameter Defaults141
- Enable/Disable All Code Types147
- UPC/EAN148
  - Enable/Disable UPC-A148
  - Enable/Disable UPC-E148
  - Enable/Disable UPC-E1149
  - Enable/Disable EAN-8/JAN-8149
  - Enable/Disable EAN-13/JAN-13150
  - Enable/Disable Bookland EAN150
  - Decode UPC/EAN/JAN Supplementals151
- User-Programmable Supplementals154
  - UPC/EAN/JAN Supplemental Redundancy154
- UPC/EAN/JAN Supplemental AIM ID Format155
- UPC Reduced Quiet Zone156
  - Transmit UPC-A Check Digit156
  - Transmit UPC-E Check Digit157
  - Transmit UPC-E1 Check Digit157
  - UPC-A Preamble158
- UPC-E Preamble159
- UPC-E1 Preamble160
- Convert UPC-E to UPC-A161
  - Convert UPC-E1 to UPC-A161
- EAN-8/JAN-8 Extend162
- Bookland ISBN Format163
- UCC Coupon Extended Code164
- Coupon Report165
- ISSN EAN166
- Code 128167
  - Enable/Disable Code 128167
- Set Lengths for Code 128168
- Enable/Disable GS1-128 (formerly UCC/EAN-128)170
  - Enable/Disable ISBT 128170
- ISBT Concatenation171
- Check ISBT Table172
  - ISBT Concatenation Redundancy172
- Code 128 Security Level173
- Code 128 Reduced Quiet Zone174
  - Ignore Code 128 <FNC4>174
- Code 128 Exclusive175
- Code 39176
  - Enable/Disable Code 39176
  - Enable/Disable Trioptic Code 39176
  - Convert Code 39 to Code 32177
- Code 32 Prefix178
- Set Lengths for Code 39179
  - Code 39 Check Digit Verification180
  - Transmit Code 39 Check Digit180
  - Code 39 Full ASCII Conversion181
- Code 39 Security Level182
- Code 39 Reduced Quiet Zone183
  - Code 39 Buffering - Scan & Store183
- Code 93186
  - Enable/Disable Code 93186
  - Set Lengths for Code 93186
- Code 11188
  - Code 11188
  - Set Lengths for Code 11188
- Code 11 Check Digit Verification190
- Transmit Code 11 Check Digits191
- Interleaved 2 of 5 (ITF)192
  - Enable/Disable Interleaved 2 of 5192
- Set Lengths for Interleaved 2 of 5193
- I 2 of 5 Check Digit Verification195
- Transmit I 2 of 5 Check Digit196
  - Convert I 2 of 5 to EAN-13196
- I 2 of 5 Security Level197
- I 2 of 5 Reduced Quiet Zone198
- Discrete 2 of 5 (DTF)199
  - Enable/Disable Discrete 2 of 5199
- Set Lengths for Discrete 2 of 5200
- Codabar (NW - 7)202
  - Enable/Disable Codabar202
  - Set Lengths for Codabar202
- CLSI Editing204
  - NOTIS Editing204
- Codabar Upper or Lower Case Start/Stop Characters Detection205
- MSI206
  - Enable/Disable MSI206
  - Set Lengths for MSI206
- MSI Check Digits208
  - Transmit MSI Check Digit(s)208
- MSI Check Digit Algorithm209
- Chinese 2 of 5210
  - Enable/Disable Chinese 2 of 5210
- Matrix 2 of 5211
  - Enable/Disable Matrix 2 of 5211
  - Set Lengths for Matrix 2 of 5211
- Matrix 2 of 5 Check Digit213
  - Transmit Matrix 2 of 5 Check Digit213
- Korean 3 of 5214
  - Enable/Disable Korean 3 of 5214
- Inverse 1D215
- GS1 DataBar216
  - GS1 DataBar-14216
  - GS1 DataBar Limited216
  - GS1 DataBar Expanded217
  - Convert GS1 DataBar to UPC/EAN217
  - GS1 DataBar Limited Security Level218
- Composite219
  - Composite CC-C219
  - Composite CC-A/B219
- Composite TLC-39220
- UPC Composite Mode221
- Composite Beep Mode222
  - GS1-128 Emulation Mode for UCC/EAN Composite Codes222
- 2D Symbologies223
  - Enable/Disable PDF417223
  - Enable/Disable MicroPDF417223
  - Code 128 Emulation224
- Data Matrix225
  - GS1 Data Matrix225
- Data Matrix Inverse226
  - Maxicode226
  - QR Code227
  - GS1 QR227
- MicroQR228
  - Inverse QR228
  - Aztec229
  - Aztec Inverse229
  - Han Xin230
  - Han Xin Inverse230
- Postal Codes231
  - US Postnet231
  - US Planet231
  - Transmit US Postal Check Digit232
  - UK Postal232
- Transmit UK Postal Check Digit233
  - Japan Postal233
- Australia Post234
- Australia Post Format235
- Netherlands KIX Code236
  - USPS 4CB/One Code/Intelligent Mail236
- UPU FICS Postal237
  - Mailmark237
- Canada Post238
- Symbology-Specific Security Levels239
  - Redundancy Level239
- Security Level241
  - 1D Quiet Zone Level242
- Intercharacter Gap Size243
- Report Version243
- Macro PDF Features244
  - Flush Macro Buffer244
  - Abort Macro PDF Entry244
OCR Programming245
- Introduction245
- OCR Programming Parameters247
  - Enable/Disable OCR-A247
  - OCR-A Variant247
- Enable/Disable OCR-B249
- OCR-B Variant250
- Enable/Disable MICR E13B253
- Enable/Disable US Currency Serial Number254
  - OCR Orientation254
- OCR Lines256
- OCR Quiet Zone258
- OCR Template259
- OCR Check Digit Validation270
- Inverse OCR275
123Scan and Software Tools276
- Introduction276
- 123Scan276
- Scanner Control App (SCA)278
- Advanced Data Formatting (ADF)278
- Multicode Data Formatting (MDF)279
- Preferred Symbol279
Maintenance and Troubleshooting280
- Introduction280
- Maintenance280
- Battery Safety Guidelines280
- Long Term Storage281
- Cleaning Instructions281
- Comfort Pad Replacement284
  - Large Comfort Pad Removal284
- Small Comfort Pad Removal285
  - Small Comfort Pad Installation285
- Large Comfort Pad Installation286
- Trigger Assembly Replacement287
  - Trigger Assembly Removal287
  - Trigger Assembly Installation287
- Converting Between Trigger and Triggerless Configuration289
  - Convert to Trigger Assembly289
  - Convert to Triggerless Assembly290
- Finger Strap Replacement (Trigger Swivel Assembly)291
  - Finger Strap Removal (Trigger Swivel Assembly)291
- Finger Strap Installation (Trigger Swivel Assembly)292
- Finger Strap Replacement (Triggerless Strap Holder)293
  - Finger Strap Removal (Triggerless Strap Holder)293
  - Finger Strap Installation (Triggerless Strap Holder)293
- Strap Buckle Replacement294
  - Strap Buckle Removal294
  - Strap Buckle Installation294
- Troubleshooting295
  - RS6000295
  - Cradles296
Specifications297
- RS6000 Technical Specifications297
- Cradle Technical Specifications301
- Decode Distances305
- Decode Range Information306
  - Standard Range Decode Zone306
- Medium Range Decode Zone307
Standard Default Parameters308
- Standard Default Parameters Table308
Programming Reference317
- Symbol Code Identifiers317
- AIM Code Identifiers318
Alphanumeric and Numeric Bar Codes323
- Numeric Bar Codes323
- Cancel324
Sample Bar Codes342
- Code 39342
- UPC/EAN342
  - UPC-A, 100%342
  - EAN-13, 100%343
- Code 128343
- Interleaved 2 of 5343
- GS1 DataBar-14343
- PDF417344
- Data Matrix344
- Maxicode344
- QR Code345
- US Postnet345
- UK Postal345
Country Codes346
- Introduction346
- Country Keyboard Types (Country Codes)347
Country Code Pages362
- Introduction362
- Country Code Page Defaults362
- Country Code Page Bar Codes366
CKJ Decode Control375
- Introduction375
- CJK Control Parameters376
  - Unicode Output Control376
- CJK Output Method to Windows Host377
- Non-CJK UTF Bar Code Output379
  - Country Keyboard Type Missing Characters379
- Unicode/CJK Decode Setup with Windows Host381
  - Setting Up the Windows Registry Table for Unicode Universal Output381
  - Adding CJK IME on Windows381
- Selecting the Simplified Chinese Input Method on the Host382
- Selecting the Traditional Chinese Input Method on the Host383
ASCII Character Sets384
INDEX394

Brand	Zebra
Model	RS6000
Category	Barcode Reader
Language	English

Zebra RS6000 User Manual

Table of Contents

Other manuals for Zebra RS6000

Questions and Answers:

Zebra RS6000 Specifications

Related product manuals