Accessories
96
Figure 46 10-Slot RS6000 Charge Only Cradle Setup
Charging the RS6000
To charge the RS6000:
1. Insert the RS6000 in the charging slot.
Figure 47 Insert RS6000 into Cradle
2. Ensure that the RS6000 is properly seated in the charging slot.
Battery Charging
The RS6000 Charging LED indicates the charging status of the battery in the RS6000. See Table 7 on page 85.
The 3,350 mAh battery fully charges in less than four hours at room temperature.
Charge batteries in temperatures from 0 °C to 40 °C (32 °F to 104 °F). The device and cradle monitor the battery
temperature. Battery charging is only performed when the battery is within safe charging temperature limits. At
higher temperatures (e.g. approximately +35 °C (+95 °F)) the device or charging cradle may for small periods of
time alternately enable and disable battery charging to keep the battery at acceptable temperatures. This process
may require additional time to complete a full charge cycle. The cradle indicates when charging is disabled due to
abnormal temperatures via the Status LED.
AC Line Cord
DC Line Cord
Power Supply
Power Input
To Next Page
Loading...
Need help?
General
