Getting Started
21
Configuration
Trigger Swivel Assembly - Change Trigger Position
The RS6000 is worn on the index and middle fingers, and triggered with the thumb. The Trigger Swivel Assembly
of the RS6000 rotates to provide left-hand or right-hand use.
To change the position of the trigger:
1. Determine whether the RS6000 is used on the right or left hand and rotate the trigger swivel assembly.
Figure 3 Change Trigger Swivel Assembly Position
Rotate the Trigger Swivel Assembly so that the Scan Trigger is positioned next to the thumb when the RS6000 is
placed on the index and middle fingers.
Charge the Battery
Before using the RS6000, charge the battery. To charge the RS6000 battery, refer to Accessories.
Install the Battery
1. Align the battery on top of the RS6000 and insert metal corner into the battery compartment.
2. Slide the battery all the way into the locking slot of the RS6000.
3. Firmly press the battery into the RS6000 until a click is heard ensuring the battery release latch is fully
engaged with the RS6000.
Trigger Swivel Assembly
Scan Trigger
CAUTION: The Trigger Swivel Assembly only rotates 180° around the front of the scan assembly. Do not rotate
the Trigger Swivel Assembly past the designed stop.
To Next Page
Loading...
Need help?
General
