57
DRIVING OPERATION
C209 C210
COOLANT HEATER
Coolant heater is fitted at the right-hand
side of the engine block.
Output 1000 W
Voltage 220 V
STARTING THE ENGINE WITH USING OF COOLANT HEATER
Heater enables starting the engine at low ambient temperature by preheating the
coolant. The electrical installation and its protection against electrical shock hazard
must be done according to the valid regulations
1. Plug the heater first.
2. Plug the cable with connected heater to 220 V mains after.
With regard to reduction of engine wear when starting at low temperatures, producer
recommends to use the heater. Preheating time depends upon the ambient
temperature (1 to 2 hours before supposed starting are sufficient).
After finishing of heating, unplug the mains first and the heater only
after!
Electrical shock hazard!
It is necessary to ensure instruction of tractor operator’s and regular
revisions of the coolant heater including inlet cable accordingly with the
valid standard of the country, in which the tractor is operated, minimum
before each winter season.
To Next Page
Loading...
Need help?
General