19
S Product Conformity
CE Marking
The ACS140 complies with the requirements of the European
• Low Voltage Directive 73/23/EEC with amendments
• EMC Directive 89/336/EEC with amendments
Corresponding declarations and a list of main standards are available on
request.
Note! See "ACS140 EMC Instructions" on page 85.
A frequency converter and a Complete Drive Module (CDM) or a Basic Drive
Module (BDM), as defined in IEC 61800-2, is not considered as a safety
related device mentioned in the Machinery Directive and related harmonised
standards. The CDM/BDM/frequency converter can be considered as a part
of safety device if the specific function of the CDM/BDM/frequency converter
fulfils the requirements of the particular safety standard. The specific
function of the CDM/BDM/frequency converter and the related safety
standard is mentioned in the documentation of the equipment.
UL, ULc and C-Tick Markings
The ACS140 has UL, cUL and C-Tick markings for all power ranges, except
C-Tick for ACS140 frame size H.
The ACS140 is suitable for use on a circuit capable of delivering not more
than 65,000 RMS symmetrical ampers (65 kA).
The ACS140 inverter must be connected to a source with 4 kV over voltage
control for 230 V AC units and 6 kV over voltage control for 480 V AC units.
T Environmental Information
A product to be disposed of contains valuable raw material that should be
recycled, thus preserving energy and natural resources. Instructions for
disposal are available from ABB sales and service companies.
www.barghmaher.org
To Next Page
Loading...
Need help?
General
