Mechanical installation of non-pre-assembled units (ACS800-04M)
113
Procedure frame size R8
The steps of this installation procedure are shown in the photo on the next page.
1. Fasten the inner support bracket to the drive module.
2. Screw the insulating supports onto the pins on the outer support bracket.
3. Slide the outer support bracket on the inner bracket.
4. Fasten the outer support bracket to the drive module.
5. Connect the AC busbars.
6. Connect the DC busbars (if ordered).
7. Connect the PE busbar.
To Next Page
Loading...
Need help?
General
