ABB ACS800-04 User Manual

About this manual
13
Installation, commissioning and operating flowchart
Task Chapters in this manual Chapters in ACS800-04/04M/U4
Hardware Manual
[3AFE64671006 (English)]
Identify the frame size of your drive, R7 or R8. - Technical data / IEC ratings or
NEMA ratings
Plan the installation.
Check the ambient conditions, ratings,
required cooling air flow, input power
connection, compatibility of the motor, motor
connection, and other technical data.
Planning the cabinet installation
If optional equipment is included, see
its manuals.
Technical data
Planning the electrical installation
Unpack and check the units.
Check that all necessary optional modules
and equipment are present and correct.
Only intact units may be started up.
Mechanical installation of pre-
assembled units (ACS800-04/U4) or
Mechanical installation of non-pre-
assembled units (ACS800-04M)
If the converter has been non-
operational for more than one year,
the converter DC link capacitors need
to be reformed. Ask ABB for
instructions.
-
Assemble and install the drive module into the
cabinet.
Mechanical installation of pre-
assembled units (ACS800-04/U4) or
Mechanical installation of non-pre-
assembled units (ACS800-04M)
Install the RDCU drive control unit. - See RDCU Drive Control Unit
Hardware Manual
[3AFE64636324 (English)]
Check the installation. Checking the installation -
Electrical installation - Safety, Planning the electrical
installation, Electrical installation,
Maintenance, Technical Data,
Resistor braking
Commissioning and operating the drive - See the appropriate firmware
manual.

ABB ACS800-04 Specifications

General

Brand	ABB
Model	ACS800-04
Category	Controller
Language	English