EL3060 CONTINUOUS GAS ANALYZERS | OI/EL3060-EN REV. A 95
Configuration of signal inputs and outputs (I/O connections)
Configuration
The signal inputs and outputs (I/O connections) can only be set in the con-
figurator (see page 53) and not in the gas analyzer.
Function
The assignments of the following are configured:
• The analog outputs (AOs),
• the digital outputs (DOs) and
• the digital inputs (DIs).
Assignment
Only one function can be assigned to each signal input or output. A function
can be assigned to several signal inputs or outputs. Depending on the num-
ber of available digital inputs several external signals can be configured.
Analog outputs
The measured values are assigned to the analog outputs (see page 39) AO1,
AO2, etc. in the order of the configuration.
A short cut menu, in which you can toggle between 0–20 mA and 4–20 mA is
opened by right-clicking the name of the analog output:
Digital outputs, digital inputs
Refer to the description of the digital I/O module (see page 39) for the
standard assignment of the digital inputs and outputs.
A short cut menu, in which you can toggle between "No Invert" and "Invert",
is opened by right-clicking the name of the digital input or output:
To Next Page
Loading...
Need help?
General
