ABB rec670 User Manual

9.2.6 Monitoring
9.2.6.1
Overview
Under monitoring there are parameters for setting Service values, current phasors,
Voltage phasors, Disturbance reports, Fault locator and the Measured value
expander block.
9.2.6.2 Service values CVMMXU
Main menu/Settings/General Settings/Monitoring/ServiceValues(MMXN)/SVR
Displays available instances of CVMMXU.
9.2.6.3 Current phasors CMMXU
Main menu/Settings/General Settings/Monitoring/CurrentPhasors(MMXU)/
CP
Displays available instances of the current phasor function CMMXU with output
regarding current amplitude, current range, phase angle, zero sequence current
magnitude and negative sequence current magnitude.
9.2.6.4 Voltage phasors VMMXU/VNMMXU
Main menu/Settings/General Settings/Monitoring/VoltagePhasors(MMXU)/
Phase-Phase/VP
Displays available instances of the voltage phasor function VMMXU with output
data for phase to phase voltage, (amplitude, phase angle). The setting parameters
for supervision levels, deadband etc. are set here
Main menu/Settings/General Settings/Monitoring/VoltagePhasors(NMMXU)/
Phase-Earth/VN
Displays available instances of the voltage phasor function VNMMXU with output
data for phase to earth voltage, (amplitude, phase angle). The setting parameters for
supervision levels, deadband etc. are set here.
9.2.6.5 Current sequence components CMSQI
Main menu/Settings/General settings/Monitoring/Current sequence
components(MSQI)/CSQ
The current sequence components are where the user sets the limits and deadband
settings for current sequence components. The designation for zero sequence
current is 3I0, for positive sequence current it is I1 and for negative sequence
current it is I2.
Section 9 1MRK 511 188-UEN C
Read and change settings
50
Operator's manual

ABB rec670 Specifications

General

Brand	ABB
Model	rec670
Category	Control Unit
Language	English