Microwave Switch/Attenuator Driver 8
34980A User’s Guide 229
Y1151A
The Y1151A supports up to two of the Agilent microwave switches
shown below.
Y1151A Switch Options Supported
(Recommended options are shaded).
Agilent Switch Description
87104A/B/C SP4T 4 port latching
87106A/B/C SP6T 6 port latching
87406B 6 port matrix
Option Name Option Number Description and Comments
Frequency Range letter suffix in model
number
All options supported
Coil Voltage STD (no options) +24VDC nominal (+20VDC to +32VDC allowed)
DC Connector Type
STD 16 pin ribbon cable header
100 Solder lugs
Can use ribbon cables with the Y1150A, or
discrete wires with the Y1155A.
Calibration
Certificate
UK6, UKS All options supported
Drive Options
STD Direct coil connections for open drain drive
T24 TTL/CMOS compatible
All switches on the same distribution board must
use the same drive mode.
T00 (87406 only) Solder lugs and TTL/5V CMOS compatible
options combined - see comments above.
To Next Page
Loading...
Need help?
General
