Agilent Technologies 34980A User Manual

Features and Functions 2
34980A User’s Guide 31
Temperature Measurement Configuration
This section contains information to help you configure the instrument
for making temperature measurements. The table below shows the
thermocouple, RTD, and thermistor types for which the instrument
supports direct measurements.
Measurement Units
• The instrument can report temperature measurements in °C (Celsius),
°F (Fahrenheit), or K (Kelvins). You can mix temperature units on
different channels within the instrument and on the same module.
• The
CONFigure and MEASure? commands automatically select °C.
• Setting the Mx+B measurement label to °C, °F, or K has no effect on
the temperature measurement units currently selected.
• The instrument selects Celsius when the probe type is changed and
after a Factory Reset (
*RST command). An Instrument Preset
(SYSTem:PRESet command) or Card Reset (SYSTem:CPON command) does
not change the units setting.
Front Panel Operation: DMM or Channel (Configure) > TEMPERATURE > UNITS
Remote Interface Operation: UNIT:TEMP {C|F|K}[,(@<ch_list>)]
Temperature transducers supported
Thermocouple Types
*
* Using ITS-90 software conversions.
RTD Types Thermistor Types
B, E, J, K, N, R, S, T R
0
= 49Ω to 2.1 kΩ
α = 0.00385 (DIN/IEC 751)
*
α = 0.00391
†
† Using IPTS-68 software conversions.
2.2 kΩ, 5 kΩ, 10 kΩ
(YSI 44000 Series)

Agilent Technologies 34980A Specifications

General

Brand	Agilent Technologies
Model	34980A
Category	Switch
Language	English