64-Bit Digital I/O Module with Memory and Counter 10
34980A User’s Guide 267
Basic Digital I/O Operations
Channel Numbering and Width
The digital channels are numbered by bank; 101 through 104 and 201
through 204 for banks 1 and 2 respectively.
Using SCPI commands you can group digital I/O channels together to
allow 16- or 32- bit operations. The first and third channels on a bank can
be control channels. Width and direction of the memory operations are
controlled by the width and direction of the first channel on the bank
(i.e., 101 or 201). In the SCPI language for the 34950A, BYTE refers to
8- bit operations, WORD refers to 16- bit operations, and LWORd refers to
32- bit operations.
This diagram illustrates how the channels are numbered for each
configuration.
Reading Digital Data
The simplest way to read a digital channel is using the MEASure:DIGital?
query. This query sets the channel to be an input channel and sets all
other channel parameters to the default settings.
For example, sending the following SCPI command to a Digital I/O module
installed in slot 1 of the mainframe will read the value of the 8- bit
channel 102. An unsigned integer value is returned that represents the
state of the 8 bits on channel 102.
MEAS:DIG? BYTE, (@1102)
By adding parameters to the command, you can set the channel width,
polarity, and threshold for read. For example, sending the following SCPI
command you can read the 32- bit channel 201.
MEAS:DIG? LWOR, (@1201)
Bank 1 Bank 2
Channel
BYTE (default) 101 102 103 104 201 202 203 204
8-bits 8-bits 8-bits 8-bits 8-bits 8-bits 8-bits 8-bits
WORD 101 103 201 203
16-bits 16-bits 16-bits 16-bits
LWORd 101 201
32-bits 32-bits
To Next Page
Loading...
Need help?
General
