Allen-Bradley SLC 500 BASIC User Manual

Publication 1764-UM001A-US-P
Installing and Wiring Your Module 3-5
Figure 3.5 JW4 Pin Assignments and Settings
Use the worksheet in appendix B to document the selected jumper setting of
jumper JW4. Documenting your selection provides others with information
necessary to integrate the module with their SLC 500 fixed or modular controllers.
351
462
SLC 500 BASIC MODULE
CAT SER SERIAL NO. FRN
JW1
12345
6789
U
L
PRT1
123
45
6789
PRT2
SA
JW2
DH485
PRT1 Port = Program port with default
communication settings
PRT2 Port = ASCII interface port
DH485 Port = Run-time DH485 only
Pin Assignments
PRT1 Port = ASCII interface port
PRT2 Port = ASCII interface port
DH485 Port = Program port with DH485 protocol
(shipped configuration)
PRT1 Port = Program port with programmed communication settings
PRT2 Port = ASCII interface port
DH485 Port = Run-time DH485 only
PRT1 Port = Program port with programmed communication settings
PRT2 Port = DF1 protocol
DH485 Port = Disabled
IMPORTANT
The first setting shown above is the default configuration. When
the jumper is set in this position, the module always powers up in
Command mode at 1200 baud, no parity, 8 data bits, and 1 stop
bit.
ATTENTION

All other jumper settings for JW4 are illegal and may cause
damage to the module.
IMPORTANT
• When DF1 protocol is selected for port PRT2, port DH485 is
not available for DH485 programming or run-time operation.
• DF1 communication must be enabled through the BASIC
program.
Spare Allen-Bradley Parts

Allen-Bradley SLC 500 BASIC Specifications

General

Brand	Allen-Bradley
Model	SLC 500 BASIC
Category	Control Unit
Language	English