1 Publication 1746-UM004A-US-P
Appendix
B
This appendix contains important information you should be concerned with
when configuring the module. The information is general in nature and
supplements specific information contained in earlier chapters of this manual.
Topics include worksheets for configuring:
• the BASIC or BASIC-T module
• jumpers JW1-JW4
Module Configuration
Specify the connection information by filling in the boxes in the figure below.
Figure 2.1 Module Configuration
What to Do Next: Give a copy of this worksheet to the hardware installer. Store
this worksheet with your application program for future reference.
Port PRT1 Configuration
(Jumper JW1)
See Figure 3.1 on page 3-1 for the locations of the four jumpers.
See Figure 3.2 on page 3-2 for jumper JW1 pin assignments and settings.
Specify the configuration of port PRT1 on your module by filling in the table
below.
IMPORTANT
When DF1 protocol is selected for port PRT2, the DH485 port
is not available for programming or run time operation.
PR T1
5
4
3
2
1
9
8
7
6
PR T2
5
4
3
2
1
9
8
7
6
DH485
BASIC
Connected Device: YES______ NO ______
Device Type: _______________________
Protocol: __________________________
Program Port: YES______ NO ______
Connected Device: YES______ NO ______
Device Type: _______________________
Protocol: _________________________
Connected Device: YES______ NO ______
Device Type: _______________________
Protocol: __________________________
Program Port: YES______ NO ______
Spare Allen-Bradley Parts
To Next Page
Loading...
Need help?
General
