OPERATING INSTRUCTIONS
COMBITHERM® CT PROFORMANCE™ SERIES • STEP-BY-STEP PROCEDURES • MN-35948 • 32.
COMBIHOOD PLUS™ VENTLESS HOOD OPTION
The CombiHood PLUS option is factory installed directly
on the top of the Alto-Shaam Combitherm CTP or CTC
series oven.
•
Using EPA method 202 testing, grease laden vapors
emitted by the Combi Ventless hood are 0.58 mg/m
3
– far
less than U.L.’s established standard of 5 mg/m
3
.
•
Alto-Shaam’s factory installed Ventless Hood is placed
directly on the top of a Combitherm oven.
•
A high-power fan captures all steam and fumes from the
oven cavity into the hood intake and out the back surface
exhaust vent, trapping grease as the air moves through
the filter system.
•
As fumes and vapors are circulated through the hood,
condensed steam drains from a drain at the rear of the
hood.
•
An activated charcoal filter cleans the air before venting it
out the top of the hood.
•
CombihoodPLUS™ performance is “smart”; engaging
the fan during the last minute of the cook mode which
provides quiet operation and consumes less power.
FRONT OF HOOD
ALIGNS WITH FRONT
OF COMBI DOOR
CONDENSATE DRAIN
A ventless hood condensate drain
line to the floor drain must be
installed. The 3/4" NPT thread
connection is found at the back
of the hood. The drain line must
always be a positive gradient away
from the Combitherm oven.
To Next Page
Loading...
Need help?
General
