OPERATING INSTRUCTIONS
COMBITHERM® CT PROFORMANCE™ SERIES • STEP-BY-STEP PROCEDURES • MN-35948 • 4.
CT PROFORMANCE™ START-UP PROCEDURES
When the oven is powered
on, the PROtouch screen
illuminates. “Loading”
indicates that the software is
booting up. The screen will also
indicate what level of progress
has been made as the software
becomes fully operational. See
illustration at left.
If, for any reason, the oven is turned off or loses power
during this start-up process, the operator will be
prompted to calibrate the Touch screen when the oven is
next powered up.
Return to Home Screen - Press the red arrow if
does not need to be calibrated.
Begin Calibration Process - Press the green
check mark if the Touch screen
does need to be
calibrated. The screen will switch to a grey background.
See illustration at right.
A crosshairs icon will appear.
The operator should touch the center intersection using
a stylus for an accurate calibration. This prompt and
required action will be repeated several times in different
areas of the Touch screen. When complete, the operator
will be returned to the Home screen.
Power ON - Activates power to the oven
and automatically fi lls the steam generator
equipped models with water that will heat to a
stand-by mode temperature of 188°F (77°C).
Power OFF - Press once to initiate power
shut down sequence to the oven. Note:
Oven will not shut down during a cooking
cycle. You may need to press rmly due to
the material thickness. From time to time, the
control may become unresponsive. ONLY in
this case, rmly press and hold the OFF key
for 10 seconds to power down the oven.
NOTE: In the event of a power failure,
the oven will not operate.
To Next Page
Loading...
Need help?
General
