AMX DAS-T0804-SIG User Manual

Installation
11
T
ango Series Audio Controllers
Connecting Sources (Audio Inputs/Outputs)
Up to eight audio devices can be connected to the Tango Controllers via the Sources INPUT and
OUTPUT RCA connectors on the rear panel (see FIG. 1 on page 1). Industry standard RCA connectors
provide line-level input and output connections for devices such as CD, DSS, MP3 players etc.
Each audio input has a corresponding buffered output used to connect the audio sources to additional
Tango Controllers or to other devices that share the audio sources (FIG. 3).
Connecting IR Outputs
Tango Controllers provide eight 3.5mm mono IR Output jacks for CC-NIRC NetLinx IR Emitter Cables
(supplied). Commands received by the Tango Controller from the Metreau keypads are processed and
sent via the IR Emitter Cable to the controlled device.
CC-NIRC NetLinx IR Emitter Cables attach to the controlled audio device’s IR sensor with double-sided
tape (included), and connect to the Tango Controller via the IR OUTPUT jacks on the rear panel
(FIG. 4).
FIG. 3 Connecting Sources (Audio IN/OUT)
FIG. 4 Connecting IR Output to an IR Sensor on a controlled audio device
R
L
1234
OUTPUT
R
L
INPUT
SOURCES
From R/L OUT jacks on
Source 1 audio device
To R/L IN jacks on additional
controllers, or other devices
that share this audio source
567 8
IR OUTPUT
12345678
CD PLAYER
IR Sensor
CC-NIRC
Tango controllers support RC5 and RC6 IR codes. Codes that fall outside of this
range may not function with the Controller.

AMX DAS-T0804-SIG Specifications

General

Brand	AMX
Model	DAS-T0804-SIG
Category	Recording Equipment
Language	English